MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Search Forums
Reload this Page Search Results
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: MarkRH
Forum: MechMates already cutting Sat 12 September 2020, 05:23
Replies: 56
Views: 83,083
Posted By MarkRH
With the proper vfd filter and wire you should...

With the proper vfd filter and wire you should not have needed sheilding on motor wires. I am about to switch mine over, will let you know what I find. Thanks
Forum: MechMates already cutting Tue 08 September 2020, 03:35
Replies: 56
Views: 83,083
Posted By MarkRH
Abdelkabir, please post what you find with that...

Abdelkabir, please post what you find with that because teknic does not spec sheilded wire for their motors, But you definately should on the vfd. Are you using their power hub? Ive found their tech...
Forum: MechMates already cutting Tue 18 August 2020, 02:31
Replies: 56
Views: 83,083
Posted By MarkRH
Abdelkabir, teknic recommends a 75v power supply,...

Abdelkabir, teknic recommends a 75v power supply, they also recommend keeping control and supply grounding separated. If your motors dont have enough torque you should see them fault out with that.
Forum: MechMates already cutting Fri 10 April 2020, 04:47
Replies: 56
Views: 83,083
Posted By MarkRH
Congrats Abdelkabir, how are you liking the acorn...

Congrats Abdelkabir, how are you liking the acorn clearpath combo? , I am switching to acorn now. Do you find the nema 23 223oz motors strong enough? Does it cut smooth arches?
Forum: MechMates already cutting Thu 28 February 2019, 02:11
Replies: 56
Views: 83,083
Posted By MarkRH
There is a thread in the gantry section on...

There is a thread in the gantry section on straightening propeller twist, if I were you id cut thru those welds with a thin disc clamp it flat and follow the welding sequence to minimise distortion.
Forum: MechMates already cutting Sun 30 December 2018, 04:57
Replies: 56
Views: 83,083
Posted By MarkRH
Looks good, how hard was it to roll over? What do...

Looks good, how hard was it to roll over? What do you guess it weighs? Im just getting to putting my table together and may have to leave legs off to have it clear ceiling height
Showing results 1 to 6 of 6

 
Forum Jump

All times are GMT -6. The time now is 00:41.

Contact Us - www.mechmate.com - Archive - Top

Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.