MechMate CNC Router Forum - Search Results

		MechMate CNC Router Forum > Search Forums
Search Results

Options

Profile

Last 1 | 3 | 7 Days

Today's Posts

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: Regnar

Forum: Driving Mechanisms: Rack/pinion, gears, screws, belts & chains

Wed 21 April 2010, 19:23

Replies: 449

Reduction Drive by belt - a collection of various designs and how to build your own.

Views: 476,874

Posted By Regnar

Thanks again, I must have looked at your thread...

Thanks again, I must have looked at your thread 30 times now and just noticed the geared motor:rolleyes:

I see you are using button caps under the gears that mount the motor. Is this what you mean...

Forum: Driving Mechanisms: Rack/pinion, gears, screws, belts & chains

Wed 21 April 2010, 17:54

Replies: 449

Reduction Drive by belt - a collection of various designs and how to build your own.

Views: 476,874

Posted By Regnar

Thanks Steve, I had thought all of them where...

Thanks Steve, I had thought all of them where built up the same but looking at other builds I had started to notice different directions. Finished countersinking all the plates today and will prep,...

Forum: Driving Mechanisms: Rack/pinion, gears, screws, belts & chains

Tue 20 April 2010, 15:54

Replies: 449

Reduction Drive by belt - a collection of various designs and how to build your own.

Views: 476,874

Posted By Regnar

Pivot Point

I was just wondering if the pivot point is on the same side in all locations. I ask because I am about to countersink all the plates for making Leo's Belt Drive setup and you can make it go either...

Forum: Driving Mechanisms: Rack/pinion, gears, screws, belts & chains

Thu 11 March 2010, 19:48

Replies: 449

Reduction Drive by belt - a collection of various designs and how to build your own.

Views: 476,874

Posted By Regnar

Steve, what sizes was the drill rod compared to...

Steve, what sizes was the drill rod compared to the pulleys. I would have figured you would have ran into the same problem with any shaft that was .500 round. Drill rod is usually within .001 of its...

Forum: Driving Mechanisms: Rack/pinion, gears, screws, belts & chains

Thu 11 March 2010, 18:57

Replies: 449

Reduction Drive by belt - a collection of various designs and how to build your own.

Views: 476,874

Posted By Regnar

Steve, I am using drill rod as well. I found that...

Steve, I am using drill rod as well. I found that the pulleys have a lip on them that will need to be sanded off and also you will need a nice tapper on the drill rod for insertion. My pulley sizes...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -6. The time now is 06:44.