MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Search Forums
Reload this Page Search Results
Register Options Profile Last 1 | 3 | 7 Days Today's Posts

Showing results 1 to 8 of 8
Search took 0.00 seconds. Search: Posts Made By: Regnar
Forum: Troubleshooting Sat 10 April 2010, 12:01
Replies: 28
Views: 28,111
Posted By Regnar
Here is a couple of drawings of the circuits in...

Here is a couple of drawings of the circuits in their different modes.
Red is positive and Green is Neutral.
Forum: Troubleshooting Fri 09 April 2010, 22:38
Replies: 28
Views: 28,111
Posted By Regnar
Steve just make sure you order the right...

Steve just make sure you order the right contactor, some fool around here is giving out bad information and is on his 5th order.:o
Forum: Troubleshooting Fri 09 April 2010, 22:20
Replies: 28
Views: 28,111
Posted By Regnar
Yeppers now I have have another order into...

Yeppers now I have have another order into FactoryMation. They must think Im nuts. I have seriously wasted a few days trying to get this figured out. I should have asked a lot sooner for help but...
Forum: Troubleshooting Fri 09 April 2010, 21:54
Replies: 28
Views: 28,111
Posted By Regnar
I think I might have found the problem. Kinda...

I think I might have found the problem. Kinda feel like an idiot but..... I am pretty sure I wanted to purchase a CN-22-F6 and not a CN-22-P6

Just to be sure could someone look at these 2 and make...
Forum: Troubleshooting Fri 09 April 2010, 21:40
Replies: 28
Views: 28,111
Posted By Regnar
When I finger it :D it does not stay latched. ...

When I finger it :D it does not stay latched.

If I went from post 14 to the light wouldnt it stay constantly on?

I went out and looked for a coil voltage and didnt seen anything. I did see a...
Forum: Troubleshooting Fri 09 April 2010, 21:14
Replies: 28
Views: 28,111
Posted By Regnar
Ok so I threw on a headlamp and did some...

Ok so I threw on a headlamp and did some measuring.

Point 1 and 5 have 120volts

Points 2 and 6 have 0 Volts until I push down the contact points the I have 120v

Point 14 has a constant 120v...
Forum: Troubleshooting Fri 09 April 2010, 20:51
Replies: 28
Views: 28,111
Posted By Regnar
Thanks for the help guys. I have been at this for...

Thanks for the help guys. I have been at this for a couple of days now and finally said uncle. The failure to latch is what I am thinking (not that I know much). I did trace all the wires for...
Forum: Troubleshooting Fri 09 April 2010, 17:29
Replies: 28
Views: 28,111
Posted By Regnar
Copied from another thread becuase it talks about...

Copied from another thread becuase it talks about what happens when you have the wrong contactor

Ok I give, I need help!

Well first I am proud of myself for not lighting anything on fire and...
Showing results 1 to 8 of 8

 
Forum Jump

All times are GMT -6. The time now is 10:35.

Contact Us - www.mechmate.com - Archive - Top

Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.