MechMate CNC Router Forum - Search Results

		MechMate CNC Router Forum > Search Forums
Search Results

Options

Profile

Last 1 | 3 | 7 Days

Today's Posts

Showing results 1 to 8 of 8
Search took 0.00 seconds. Search: Posts Made By: IMMark

Forum: MechMates already cutting

Tue 06 May 2014, 15:24

Replies: 414

Cutting Wing Rib Forms #118 - Oklahoma USA

Views: 225,444

Posted By IMMark

Congrats on #118.....that's a fine number! Mark

Congrats on #118.....that's a fine number!
Mark

Forum: MechMates already cutting

Sun 04 May 2014, 08:02

Replies: 414

Cutting Wing Rib Forms #118 - Oklahoma USA

Views: 225,444

Posted By IMMark

I guess, I meant ...could you make a hard stop...

I guess, I meant ...could you make a hard stop that corresponds to the dust foot. As a fail safe, so the dust foot can't hit the table?

Forum: MechMates already cutting

Sun 04 May 2014, 07:37

Replies: 414

Cutting Wing Rib Forms #118 - Oklahoma USA

Views: 225,444

Posted By IMMark

Will the Z hard stop prevent it from going that...

Will the Z hard stop prevent it from going that low?
I think the "sweep" material is available from Home Depot, etc. as a sweep for door bottoms? (At least I think I have seen it there, going to be...

Forum: MechMates already cutting

Sun 20 April 2014, 18:23

Replies: 414

Cutting Wing Rib Forms #118 - Oklahoma USA

Views: 225,444

Posted By IMMark

Thanks Ger and Pete...sounds like too much...

Thanks Ger and Pete...sounds like too much water...
Mark

Forum: MechMates already cutting

Sun 20 April 2014, 09:35

Replies: 414

Cutting Wing Rib Forms #118 - Oklahoma USA

Views: 225,444

Posted By IMMark

Would a pump like this one work, assuming you...

Would a pump like this one work, assuming you would use with a tank under the machine?
Thanks for any thoughts....

Forum: MechMates already cutting

Sun 16 February 2014, 15:57

Replies: 414

Cutting Wing Rib Forms #118 - Oklahoma USA

Views: 225,444

Posted By IMMark

I got the spider frame as level as possible, then...

I got the spider frame as level as possible, then put the whole thing on the milling machine to take the last few thousands off the bearing supports. My machine is not finished yet, so I will leave...

Forum: MechMates already cutting

Sun 16 February 2014, 12:58

Replies: 414

Cutting Wing Rib Forms #118 - Oklahoma USA

Views: 225,444

Posted By IMMark

I think if you weld the bearing supports, you can...

I think if you weld the bearing supports, you can then "fine tune" the flatness ...but milling, sanding (whatever) the supports to get it totally flat.
Mark

Forum: MechMates already cutting

Fri 03 January 2014, 10:00

Replies: 414

Cutting Wing Rib Forms #118 - Oklahoma USA

Views: 225,444

Posted By IMMark

I think you want to countersink those holes prior...

I think you want to countersink those holes prior to welding?
I will leave it to the pros to verify.
Best of luck!
Mark

Showing results 1 to 8 of 8

Forum Jump

All times are GMT -6. The time now is 17:15.