MechMate CNC Router Forum - Search Results

		MechMate CNC Router Forum > Search Forums
Search Results

Options

Profile

Last 1 | 3 | 7 Days

Today's Posts

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: Rusty Nuts

Forum: Motors & their mountings

Tue 06 September 2011, 19:37

Replies: 8

Need help, two nights and no sleep

Views: 14,318

Posted By Rusty Nuts

Thanks Ger I transfered my license from Mach...

Thanks Ger

I transfered my license from Mach 2 to Mach 3. I upped the kernal speed to 35000 and made a big improvement. I have limited the top speed to 900 ipm.
although I was able to get over...

Forum: Motors & their mountings

Thu 01 September 2011, 20:44

Replies: 8

Need help, two nights and no sleep

Views: 14,318

Posted By Rusty Nuts

Thanks Mike, I will leave the steppers wired...

Thanks Mike,

I will leave the steppers wired half coil as you suggested. If I remember the pinions are 1" dia. pitch but will have to double check. I"ll be using 3:1 belt reduction. I transfered...

Forum: Motors & their mountings

Thu 01 September 2011, 13:29

Replies: 8

Need help, two nights and no sleep

Views: 14,318

Posted By Rusty Nuts

Hi Mike, I don't think there is anything...

Hi Mike,

I don't think there is anything wrong. I had emailed PMDX support and I received an e-mail from them this morning. When reading the manual I misread 1000 rpm as the ramp speed but the...

Forum: Motors & their mountings

Wed 31 August 2011, 20:38

Replies: 8

Need help, two nights and no sleep

Views: 14,318

Posted By Rusty Nuts

Forgot to mention the steppers are wired half...

Forgot to mention the steppers are wired half coil and also tried bipolar parallel.

Thanks
Gary

Forum: Motors & their mountings

Wed 31 August 2011, 20:33

Replies: 8

Need help, two nights and no sleep

Views: 14,318

Posted By Rusty Nuts

Need help, two nights and no sleep

I'm working on the kitchen table project. Everything is wired up with the motors on the table. My problem is I cannot get any speed from the motors.

My setup:

PMDX-126 BOB
PMDX-134 Mother...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -6. The time now is 01:59.