MechMate CNC Router Forum
>
Search Forums
Search Results
User Name
Remember Me?
Password
Register
Options
Profile
Last
1
|
3
|
7
Days
Today's Posts
Search
Search Forums
Show Threads
Show Posts
Advanced Search
Go to Page...
Showing results 1 to 3 of 3
Search took
0.00
seconds.
Search:
Posts Made By:
Dirk
Forum:
Motors & their mountings
Fri 12 October 2007, 10:29
Replies:
47
Unipolar, Bipolar series, Bipolar parallel, choices for 2phase steppers
Views:
76,186
Posted By
Dirk
I think Orientals rating on their gearboxes are...
I think Orientals rating on their gearboxes are very conservative. To my knowledge there hasn't been a failure since Shopbot started using them. You might also note that these are virtually the same...
Forum:
Motors & their mountings
Fri 12 October 2007, 09:23
Replies:
47
Unipolar, Bipolar series, Bipolar parallel, choices for 2phase steppers
Views:
76,186
Posted By
Dirk
Gerald, I don’t know of a downside using...
Gerald,
I don’t know of a downside using bipolar parallel. The motors run as smooth as series.
I’m not sure I would run the A2A at half coil, as its runs very well running full coil. I think...
Forum:
Motors & their mountings
Thu 11 October 2007, 22:31
Replies:
47
Unipolar, Bipolar series, Bipolar parallel, choices for 2phase steppers
Views:
76,186
Posted By
Dirk
I’ve found the A1A motor performs much better...
I’ve found the A1A motor performs much better using a half coil connection. The reason for this is the extremely high inductance of this particular motor. Lower inductance usually means higher...
Showing results 1 to 3 of 3
Forum Jump
User Control Panel
Private Messages
Subscriptions
Who's Online
Search Forums
Forums Home
General - MM Build
About this Forum
The Market Place
Personal Build Histories
Introduce yourself and start planning
Construction started, but not cutting yet
MechMates already cutting
Structure & Mechanics
10. Base Table
20. Gantry
30. Y-Car
40. Z-Slide
50. Toolheads
55. Dust Management
Common Assemblies & Parts
Profiled (laser cut) & bent steel plate
Motors & their mountings
Rails & Rollers
Driving Mechanisms: Rack/pinion, gears, screws, belts & chains
Electrical & Electronic
60. Wiring & Cable Management
70. Control Systems
701. Motor Drives
702. Power Supplies
Computing, Software & Programming
80. Computer Hardware & Software
Graphics & CAD
CAM
CNC motion control software
Utility software
After Building the Beast - Operating , Troubleshooting and Maintenance
General - MM Operating
Cutting various materials - bit selection, feeds, speeds
Troubleshooting
Maintenance
The Show Room
Miscellaneous hardware and software
Human Interface Devices (HID's)
Miscellaneous / General / Whatever / Catchall
Golden Resources
Test Area for this forum
Downloads
Dxf Library
Archives
All times are GMT -6. The time now is
23:21
.
Contact Us
-
www.mechmate.com
-
Archive
-
Top
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.