Forum: MechMates already cutting
Thu 05 April 2012, 03:24
|
Replies: 189
Views: 248,600
My bad. :o
45in/min... = 19.05mm/second. ...
My bad. :o
45in/min... = 19.05mm/second.
That is actually slower then what I did, 25mm/sec.
The difference is I use HSS end mill bits at 2000rpm. with ample of kerosene applied with a small...
|
Forum: MechMates already cutting
Wed 04 April 2012, 21:07
|
Replies: 189
Views: 248,600
wow, .05" (1.27mm) depth at 45ipm (1143mm/sec)...
wow, .05" (1.27mm) depth at 45ipm (1143mm/sec) that is aggressive! did you observe what is thr highest spindle current drawn?
You really need to be careful not to plunge your bit too fast or it...
|
Forum: MechMates already cutting
Mon 19 March 2012, 02:20
|
Replies: 189
Views: 248,600
|
Forum: MechMates already cutting
Wed 14 March 2012, 05:53
|
Replies: 189
Views: 248,600
|
Forum: MechMates already cutting
Wed 07 March 2012, 19:45
|
Replies: 189
Views: 248,600
|
Forum: MechMates already cutting
Tue 21 February 2012, 21:51
|
Replies: 189
Views: 248,600
|
Forum: MechMates already cutting
Mon 20 February 2012, 22:01
|
Replies: 189
Views: 248,600
Congrats! Dust at last!!!
Before I had my dust...
Congrats! Dust at last!!!
Before I had my dust collector in place, I have think trice before I cut anything...
The dust is worst with MDF, solid wood makes wood chips which are lesser hassle but...
|
Forum: MechMates already cutting
Wed 08 February 2012, 23:35
|
Replies: 189
Views: 248,600
Great effort to details! Very professionally...
Great effort to details! Very professionally done. You should be manufacturing a lot of dust very soon!
What is that thingy with blue sticker at the top right corner of the control penal?
Charles,...
|
Forum: MechMates already cutting
Fri 04 November 2011, 02:32
|
Replies: 189
Views: 248,600
|
Forum: MechMates already cutting
Fri 21 October 2011, 05:29
|
Replies: 189
Views: 248,600
There are no hard & fast spec. for the cable...
There are no hard & fast spec. for the cable chain, as long as
1) it can take in all the stuff you decided to chuck in,
2) the un-supported length is sufficient for your needs
3) fits your bank...
|
Forum: MechMates already cutting
Mon 12 September 2011, 04:12
|
Replies: 189
Views: 248,600
Welcome.
While you are waiting, I strongly...
Welcome.
While you are waiting, I strongly recommend to go through the whole forum thread by threat, post by post & word by word,,,, over & over again...
The basic CNC router use a router...
|