MechMate CNC Router Forum

Go Back   MechMate CNC Router Forum > Search Forums
Reload this Page Search Results
Register Options Profile Last 1 | 3 | 7 Days Search Today's Posts Mark Forums Read

Showing results 1 to 8 of 8
Search took 0.00 seconds. Search: Posts Made By: KenC
Forum: Construction started, but not cutting yet Thu 13 May 2010, 01:22
Replies: 136
Views: 201,731
Posted By KenC
Well done! With your perservere attention to...

Well done!
With your perservere attention to details, the rails would be a breeze.
Forum: Construction started, but not cutting yet Wed 28 April 2010, 01:58
Replies: 136
Views: 201,731
Posted By KenC
Another note, I have 3 phase 415V available, I...

Another note,
I have 3 phase 415V available, I split the phases for separate usage. i.e. the PC is running off a separate phase, the control panel on a separate phase & the VFD runs on another...
Forum: Construction started, but not cutting yet Tue 27 April 2010, 20:57
Replies: 136
Views: 201,731
Posted By KenC
Hi Gerald, Steve, I used ribbon cable because ...

Hi Gerald, Steve,
I used ribbon cable because
1) compactness hence easy laying out & installation
2) came with the BOB.
3) IMHO, my layout allow that.
4) you can call it a learning experience...
Forum: Construction started, but not cutting yet Tue 27 April 2010, 01:13
Replies: 136
Views: 201,731
Posted By KenC
Steve you can get away with unshield cable...

Steve you can get away with unshield cable between the driver & BOB. I used cost effective ribbon cable for this & I shielded the cable from the driver to the motor.
Forum: Construction started, but not cutting yet Fri 05 February 2010, 01:44
Replies: 136
Views: 201,731
Posted By KenC
No worries, I'll just hand make one, it will be...

No worries, I'll just hand make one, it will be faster then getting them laser cut. Problem is I need to find a piece of scrap plate.... some where... some how...:(
Forum: Construction started, but not cutting yet Thu 04 February 2010, 06:33
Replies: 136
Views: 201,731
Posted By KenC
I just realized I don't have that M1 30 332 in my...

I just realized I don't have that M1 30 332 in my laser cut pack...
Forum: Construction started, but not cutting yet Tue 02 February 2010, 23:55
Replies: 136
Views: 201,731
Posted By KenC
Nice touch on the beam end.... So nice to have a...

Nice touch on the beam end.... So nice to have a plasma cutter in hand.
Forum: Construction started, but not cutting yet Wed 13 January 2010, 18:55
Replies: 136
Views: 201,731
Posted By KenC
After grinding the rails, I wished I had my...

After grinding the rails, I wished I had my wheels made out of brass...
Showing results 1 to 8 of 8

 
Forum Jump

All times are GMT -6. The time now is 12:42.

Contact Us - www.mechmate.com - Archive - Top

Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.