MechMate CNC Router Forum - Search Results

		MechMate CNC Router Forum > Search Forums
Search Results

Options

Profile

Last 1 | 3 | 7 Days

Today's Posts

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: toad

Forum: Troubleshooting

Fri 30 July 2010, 19:33

Replies: 17

Motors Will Not Turn - Step & Direction wires crossed by mistake

Views: 13,389

Posted By toad

I just want to say thank you all for your...

I just want to say thank you all for your assistance. That worked, now they turn. I can sleep well tonight.
Again, Thank you.

Toad

Forum: Troubleshooting

Thu 29 July 2010, 19:22

Replies: 17

Motors Will Not Turn - Step & Direction wires crossed by mistake

Views: 13,389

Posted By toad

Hi all, thanks for your help so far, I did...

Hi all, thanks for your help so far,
I did find I had the charge pump incorrect, I am closer, but not there yet. I have looked at all of the tutorials as was suggested. You are correct, I did post...

Forum: Troubleshooting

Wed 28 July 2010, 19:30

Replies: 17

Motors Will Not Turn - Step & Direction wires crossed by mistake

Views: 13,389

Posted By toad

Hi Pablo, Where in Mach 3 do you enable the...

Hi Pablo,

Where in Mach 3 do you enable the charge pump on pin 17, the only place I see to enable it is in the general config settings?

Toad

Forum: Troubleshooting

Wed 28 July 2010, 17:22

Replies: 17

Motors Will Not Turn - Step & Direction wires crossed by mistake

Views: 13,389

Posted By toad

Motors Will Not Turn - Step & Direction wires crossed by mistake

I have the panel wired and have ran into a snag. I have 4 PK299 F4.5V They are wired to the Gecko drive G203V A+,A-,B+ B- The BOB is PHDX-122. Powered by 12V. The Step, Drive and Direction are wired...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -6. The time now is 06:10.