Room Divider Panel
1 Attachment(s)
I want to show you a panel which I made. Size of this is 190x90cm.
Different sizes and multiple panels form nice room dividers for restaurants, offices or homes...whats your opinion ?:) Attachment 8327 |
How long did this take to cut and at what speeds??
|
Very nice, I wanted to try something similar on a handrail. Where did you get the design? Very cool.
|
It's spectacular. In the other thread you indicated that it took 30 hours?
|
What did you do about the scrap coming out of the holes? (If left as blocks, they jump up and jam the cutter......or they can be turned completely into sawdust)
|
Thanks,
Gerald I set up tabs one for each block, the remaining thing from the tab disappeard when I chamfered the other side. I allready imagined me sitting for a month sanding the little tab leftovers... Jim, in Exact Stop mode the cutting took 13 hours, then another 7 hours chamfering for EACH side. I left it work alone in the dark.... |
removing the left overs manually is a PITA.
if you have space below the job - then without tabs, these pieces simply fall off |
Claus, I believe that job can be cut very much quicker with different Mach settings, but I havn't played with settings for years and I couldn't suggest where to start.
|
Agree with G' - say 4 hrs of thru cuts and 2 hrs with V
|
I also believe that it can be done faster, but as a newbie I`m still experimenting with CV and Exact Stop. Have to do some more and find out the faster way keeping also the quality. As this is the piece I want to show to potential customers quality was most important !
|
CNC done by CNC
3 Attachment(s)
This is a small size diy cnc made from MDF.
Size is 1300 mm x 600 mm. All parts are cut from 18 mm MDF. This is how it should look loke when it`s finished. Attachment 8576 The Job took 1 hour to cut in two passes with a 4 mm end mill. Velocity was set to 3800 mm/min. Attachment 8579 Attachment 8577 Of course I did not post the cnc base which is a simple square base and not worth mentioning.:) I was happy that no symptoms happend during this job. You can also watch the cutting sequence with my new CV Setup. Here and here. |
claus please post your CV setup, I need to know how to slow down the machine when changing directions. :)
|
Irfan, I´ve posted the CV settings in the troubleshooting section here .
|
Thanks Claus
|
Is it your Design or a Customer job ..etc.etc ??
-- This is a small size diy cnc made from MDF. --
/oopz |
I wish I could design something like that. :) I did that for a customer, just the cutting.
...but I can find out if its available free if you´re interested... |
All times are GMT -6. The time now is 23:01. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.