Zero touch place not connecting
I am running mach3 BOB PMDX-122 Gecko drive G203v.
been running for a few years with no problems. just had a problem popped up i went to zero to the table top using the zero plate when i ran the zero. The spindle moved down but did not stop when it touch the plate. have to hit the page up for it to go back up. been using a piece of paper to zero. any idea where to start looking to correct this? Paul |
On the last page of the mach screen you can view the inputs. Touch the plate to a good ground while watchine the inputs. Sometimes older routers don't ground through them after lots of running. If the input works as shown on the screen, I would suspect the router is not passing ground. You can replace the router or use a ground wire clip on the bit if that is the case.
|
Thanks Kenrbass
Found it it was a broken connection on the z zero plate lead |
All times are GMT -6. The time now is 03:35. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.