MechMate CNC Router Forum

MechMate CNC Router Forum (http://www.mechmate.com/forums/index.php)
-   60. Wiring & Cable Management (http://www.mechmate.com/forums/forumdisplay.php?f=4)
-   -   Router / Spindle cable management (http://www.mechmate.com/forums/showthread.php?t=1035)

gmessler Sun 19 October 2008 18:39

Router / Spindle cable management
 
For those of you with working Mechmates, how are you handling the wiring management of the z-slide? I think this would include cabling for the router/spindle power, ground wire, and in some cases the prox switch.:confused:

smreish Sun 19 October 2008 19:01

Greg,
I have a very stiff 3 core 12GA wiring for the router which I loop up and over the slide and zip tie to a nice hole I drilled in the slide plate. I will be adding cable chain to the slide in the very near future to make it all look sexy.
JR, I think has one of the cleanest arrangements I have seen so far.

Sean


All times are GMT -6. The time now is 04:16.

Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.