Flower Carvings and Skateboards! - Littleton, CO
2 Attachment(s)
|
what are the bits you used and speed and time it took to complete
good one - did you have to sand it? |
Flower
Nice work!
|
Justin,
That is very nice job. |
Well done & thanks for the tip ! ;)
|
Very Nice, more info on finishing too! :)
|
4 min rough pass w 1/4" ball nose, 26 min finishing pass w 1/8" ball nose. I was not contracted to do the finishing so I did not sand them. I only have these back because they want more and I need to match them up with the new ones. I think I did something like 60ipm on the rough and 50ipm on the finish.
|
very beautiful and i like the staining :)
|
Long Boards
2 Attachment(s)
Cut some prototype skateboards of a local company here.
|
HPL desk for a vets office
5 Attachment(s)
I could not have done this job without my Mechmate.
|
Pretty!
|
Nice!
|
is it MDF ? mélamine ?
|
It is particle board with Laminate 2 sides. I had the laminate laid up by a local company here.
|
Hi Justin
Did you carve a curve into both sides of the skateboards? What was the cutting sequence. Thanks David |
Hi David,
Are you talking about top and bottom curve? These boards are just flat. I will be doing some boards that will be laminated into a curve. That will be down the road. Justin |
All times are GMT -6. The time now is 14:58. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.