Glitches in cut paths (rounded corners) - Using the Constant Velocity mode of Mach
1 Attachment(s)
It does cut, here's proof. Got tired of looking a file, this one comes with mach3.
|
JR, that "o" in Artsoft, is there a glitch at the 3-o'clock position, on the inner curve? Any signs of machine resonance and rough cutting, particularly on those slow curves in the word "Mach 3"?
|
3 Attachment(s)
1. No glitch. It's the point where it raises and lowers each Z move, I corrected some be extending the X & Y travel. It's rounding the vertical corners, there is a setting in Mach that fixes that just can't remember where, but I'll find it.
2. Not much, it will easily pass my scrutiny test. 3. Remember I didn't setup this file Art did. That was the second thing I changed (to Z.25) the first was the feed rate from F1.3 to F35. I've got to assume the file was setup for a milling machine and Alu. |
|
All times are GMT -6. The time now is 13:48. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.