MechMate CNC Router Forum

MechMate CNC Router Forum (http://www.mechmate.com/forums/index.php)
-   80. Computer Hardware & Software (http://www.mechmate.com/forums/forumdisplay.php?f=7)
-   -   Wireless Controller Software Alternative (http://www.mechmate.com/forums/showthread.php?t=4384)

Surfcnc Thu 30 January 2014 20:42

Wireless Controller Software Alternative
 
Hi all

I have been corresponding with Robert about the Logitech Wireless RumblePad Controller.
The Logitech Profiller software occasionally made the gantry move without it being requested on startup.
Typically it was a short move that could be counter acted with the controller.
It was easily settled on a restart.

Anyway with further testing I found that the wired F310, the wireless Rumblepad2 and the wireless F710 all had the same quirk.
This is obviously a software issue not a hardware issue.

I then searched for alternative software and came across the http://xpadder.com/ software.
It is $11 AUD for the software and it keymaps very nicely to control the Mechmate.
Using this alternative software all unrequested movement problems have now gone away.
Occasionally the Z axis won't move, but simply switching the focus to the Xpadder software and actuating the buttons always seem to get it moving again.
There are green indicator lights on the software interface that show when a button is being pressed, so it is very easy to tell if the software is registering the keypress.

So if anyone cares to test the software and give some feedback I would appreciate it.
Also if anyone has further suggestions about good, controller model non specific software also feel free to chip in.

Regards
Ross

darren salyer Thu 30 January 2014 20:58

interesting. I may raid my sons gaming area.


All times are GMT -6. The time now is 08:37.

Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.