Power supply insulation
hi there
i am newbie to this field of CNC and electronics:confused:, below is similar power supply that i use, i would like to know how to permanently insulate the AC part of the power supply?? is there any glue that i can buy. so that ones my wiring is done i could just insulate AC side:) thanks in advance http://image.made-in-china.com/2f0j0...5W-GK-50W-.jpg |
Don't understand your question.
|
Hi Raju,
are you building an MM ? -> a Toroid powersupply is recommended instead of the regulated one you posted. There's a DIY powersupply section on this forum where you can find all info you need. Not building an MM ? -> Try cnczone.com for better luck. |
You could use, hot melt plastic gun and pour it over the contacts after you screw down the wires, if you are afraid of something getting in contact with AC clamps
|
All times are GMT -6. The time now is 15:19. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.