Relays
Hi has anyone used one of these relay boards with their proximity sensors or got thoughts/ advice on them, just finishing the shopping list and then ill make a start putting it all together. Thanks
http://www.ebay.com/itm/12V-4-Channe...#ht_4202wt_934 |
I'm a little confused here. If I understand that board correctly, it's for outputs - you provide 12v to operate the relays, and a signal from a microprocessor can switch them - the output stage can support 120-240v, up to 10A.
Since the proxys are inputs to the computer, I don't understand how this board would apply. Did I miss something? |
Depending on your BOB and sensors you may not need relays at all. I don't have any with the PMDX125
|
relay board
Thanks both of you for the replies,thought i had the right board but looks like i need to carry on looking, any ideas where i can get a board as Gerald describes in earlier posts. Thanks
|
What BOB are you using?
|
breakout board
Hi mike its this one from a uk supplier http://www.diycnc.co.uk/html/uniport.html
|
All times are GMT -6. The time now is 10:39. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.