motor tuning g-force in Mach preferred settings
In the motor tuning section of Mach3/4 what is the preferred setting for g-force given the weight of a typical mechmate build?
|
Mine is set at .081503. The software determined that for me. I could not find a preferred setting, based on weight. I suspect that it would also depend on the motor setup, you have configured. I use a (slow) cutting straight drive setup.
|
All times are GMT -6. The time now is 05:21. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.