Cut list ...
 

I am trying really hard to compose a cut list

do I understand the follow below correctly ?

thanks in advance Jason

http://i234.photobucket.com/albums/e...92/jason-1.jpg

I found the answer ... thanks

Where did you find the answer?

well ..
 

your right i didnt find it

i just did more reading and grew more confident with my answers and couldnt delete my post

i couldnt find 3-4 , i was pretty sure about the rest

you would tell me if they were wrong ?

jason

That all looks correct; in the picture, #1 and #2 also have 1010324 on their ends and
#21-#24 have 1010334 on their ends.

Note that there aren't just two of #3/#4 1010302 - those are the two end bearers out of the set of cross bearers shown on 1010300; often there are 8 for standard size sheet goods, but it depends on the table length.

thank you

i couldnt figure out if there was 3 and 4 and then 8 more 1010302

yes i see the end caps and wont forget them

thank you again

start building and if there is something missing you know that you missed something don`t forget the decals at the end most oaks leave it till the end and then it is a race to get that number.Get the logo first !!!:D Bet you will have something standing in your shop soon to stick it on.

hmmm ...
 

Its true , I havent completed a mechmate , or even started on one ...

I have come to understand , the mechmate in the plans might not be for me ... as you guys already knew ... as it rather large and industrious ...

however I have completed over 20 classes in my quest to complete a CnC table ...

I have thought myself Vcarve and much trial and effort was able to this create file ...

http://i234.photobucket.com/albums/e...mm92/final.jpg

then I was able to cut this ...

http://i234.photobucket.com/albums/e...2/IMG_5273.jpg

and create this ...

http://i234.photobucket.com/albums/e...2/IMG_5436.jpg
http://i234.photobucket.com/albums/e...2/IMG_5435.jpg
http://i234.photobucket.com/albums/e...2/IMG_5428.jpg

Yesterday , I almost completed this .. just waiting on the tmolding ... before I install

http://i234.photobucket.com/albums/e...2/IMG_0030.jpg
http://i234.photobucket.com/albums/e...2/IMG_0033.jpg
http://i234.photobucket.com/albums/e...2/IMG_0028.jpg
http://i234.photobucket.com/albums/e...2/IMG_0023.jpg

today I am starting on my 3rd project ... something like a single unit one these ..

http://photos.mlive.com/detroit/2011...room_to_4.html

I am currently having to much fun to build a mechmate or something like it , but I will be back ...

Jason

Is your "tiger" stuff a laser engraving ?
If yes, what is the power of your laser and advance settings ?

No worries ..
 

Yes my Tiger stuff is laser engraved ... and I cant recall the settings off the top of my head ... I know it took several passes on both vector and raster mode ... before I was happy .. I can look them up for you later today ...

Here is a sign I am currently creating for the CnC with the different tool paths I am learning ... might cut it soon ...

http://i234.photobucket.com/albums/e.../0304pdate.jpg

hope you liked my work ... Jason