Problem with Tabs ... it leaves vertical signs
1 Attachment(s)
Ciao,
I have this problem, when the machmate raise the mill do do the tabs, it leave vertical signs in correspondance of its up-down. A picture for better explaining. Any idea ? Thanks Sergio |
Sergio use 3d tabs.The cutter needs to stop and then go up, move and then go down.
|
Quote:
thanks |
The tab is like a little triangle meaning that the cutter moves up while it cuts forward.
|
1 Attachment(s)
Use the tab shape at the bottom:
Attachment 13319 |
Wow.Ok thanks I understand now. I 'll try tomorrows.
Thanks |
Like many, I too have found that using 3d tabs solves the problem, but only if the CAM supports it.
|
just becose we are talking of tabs .... does visualmill support 3D tabs ? and does visual mill let you choose where to put tabs ? (I mean exacli put the tabs where you want them ... like vectric's products)
thanks |
looking at the videos here
http://www.mecsoft.com/Training/VMTo...thMethods.html it shows only standard tabs |
thanks Danilo. I saw that new version has manual editing tabs but no 3dtabs
|
I knew someone would do a drawing:)
|
Jou bliksem, ek het gevoel hoe druk jy vir my!
|
:eek:
|
:)
(google translate) |
Google translate is a bit rough, but for Hennie they may be accurate. Actually we also use bliksem for scoundrel. :D
|
And it is so unique to our Mother language Afrikaans.It has some other meanings also,I am going to hit you,( Ek gaan jou bliksem!) or You are a noughty small boy, ( Jou klein bliksem .) or Look at that lightning .( Kyk na daai bliksem straal ) or If you were in a bar fight of some sort and you got the worst of it then we would say ( Kyk hulle het vir hom goed gebliksem .):)
|
All times are GMT -6. The time now is 09:44. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.