Mach3 to HY series VFD on/off control
Hello all,
I had to replace the spindle on my CNC router after the winding went bad. I took a chance and purchased an Air Cooled 4kw Chinese spindle and VFD, the spindle works good when I used the VFD to stop/start it. I used the same connections on the new VFD- DCM & FOR as were used on my old one. I went into the programming menu and changed pd001 to 1 and pd002 to1. I also made the changes to the ports/ pins output setting in mach3. I still have no stop/ start via mach. Any help would be greatly appreciated. thanks Jon Alwine |
Jon,
Are you certain that the DCM and FOR are the correct location? Additionally, check to make sure there is not a secondary setting after enabling the contact closure for "std run or " 3 - wire run" functionality. On occasion, you have to also tell it to DISABLE looking for a rs232, +/- 10VDC or 4-20ma potentiometer control. Can you post a link to the manual, I might be able to assist further. Sean |
The next to the last post on this thread has a wiring diagram along with good info on setting it up. It helped me quite a bit, but I am not running Mach, so I can't help on that section.
http://www.mechmate.com/forums/showt...hlight=chinese Ken |
All times are GMT -6. The time now is 00:12. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.