MechMate CNC Router Forum

MechMate CNC Router Forum (http://www.mechmate.com/forums/index.php)
-   Troubleshooting (http://www.mechmate.com/forums/forumdisplay.php?f=83)
-   -   motor tuning g-force in Mach preferred settings (http://www.mechmate.com/forums/showthread.php?t=5718)

caddzeus Mon 06 May 2019 21:11

motor tuning g-force in Mach preferred settings
 
In the motor tuning section of Mach3/4 what is the preferred setting for g-force given the weight of a typical mechmate build?

IamDave Thu 30 May 2019 07:03

Mine is set at .081503. The software determined that for me. I could not find a preferred setting, based on weight. I suspect that it would also depend on the motor setup, you have configured. I use a (slow) cutting straight drive setup.


All times are GMT -6. The time now is 10:55.

Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.