MechMate CNC Router Forum - 3d routing of EVA foam

MechMate CNC Router Forum (http://www.mechmate.com/forums/index.php)

- General - MM Build (http://www.mechmate.com/forums/forumdisplay.php?f=11)

- - 3d routing of EVA foam (http://www.mechmate.com/forums/showthread.php?t=4071)

lunaj76

Tue 07 May 2013 23:03

3d routing of EVA foam

Hi,

Looking for any info on routing EVA foam. Is it even possible to get good 3d cuts in this stuff? I have had very little practice cutting it. Having a hard time finding a guru in EVA FOAM 3d routing. Any help or lead would be of great help.

Thanks

Justin

smreish

Wed 08 May 2013 04:39

Justin,
Visit http://www.hartlauer-bits.com/ or call him to discuss the right cutting tool for this foam. It's flexible, It's soft...usually requires a decent vac holddown to keep it from moving or cupping up into the tool if your pocketing a large area in the middle.

I don't have a lot of experience, but I have cut it.

lunaj76

Wed 08 May 2013 18:32

Thanks Sean!

All times are GMT -6. The time now is 15:11.