shaft coupling or timing pulleys?
In this moment I’m assembling my first CNC and I have some doubts about how to couple the motors to the axis, I’m going to build a small machine 70”x 40” x 20” and I have some 640 oz step motors and some screwballs to do it, however I wonder if it is OK to couple using shaft couplings or to use timing pulleys with some kind of relation, what is the best way to do it , thanks for your help.
|
have you dig the forum yet?
|
Yes, I did it.
|
Its your choice really. The beauty of engineering is nothing is cast in stone.
|
Ball screws are best connected with a coupler that will relieve any misalignment. Unless your ball screw is very coarse, I would not reduce the coupling.
|
All times are GMT -6. The time now is 09:38. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.