jehayes |
Sat 15 August 2009 21:10 |
Rail grinding process question
I have 2-1/2 by 2" angle iron stock. When cutting it down to the 1.1" required for the finished rail what is the correct process? Should I cut it first horizontally before cutting the angles on it? Or should I just grind the angles until I reach the final height? If I cut it first horizontally, to what height before starting to grind the angles? Or should I just go right to 1.1"? (I have seen all the photos and videos of folks cutting the angles horizontally first but haven't seen anything about the intermediate height, if any.) Thanks :confused:
|