MechMate CNC Router Forum - No 5V supply out of PC

MechMate CNC Router Forum (http://www.mechmate.com/forums/index.php)

- Troubleshooting (http://www.mechmate.com/forums/forumdisplay.php?f=83)

- - No 5V supply out of PC - Polarity reversed (http://www.mechmate.com/forums/showthread.php?t=1074)

J.R. Hatcher

Wed 23 January 2008 21:27

No 5V supply out of PC - Polarity reversed

I tried to setup the software today and discovered I have no 5 volt output from the power supply. I'll pull it tomorrow and trouble shoot. So no cuts today:(

J.R. Hatcher

Thu 24 January 2008 16:50

Confession time. The power supply problem last nite was operator error. Wired the 5 volt DC backwards - to + and + to -, didn't seem to hurt anything :o

All times are GMT -6. The time now is 01:58.