Model Bridge for the President of the country
Well this was my first job!
Its not typical Mechmate task but I was only one to accept to make the model of this dual bridge in two days! Ofcourse MM helped a lot :) It was delivered to the President of Republika Srpska as a gift from our country as the bridge is on Sava river between our two countrys. Enjoy the pictures! Its made of pressed pvc "Forex" very nice material and lightweight. http://www.md-tim.com/mechmate/most/most1.jpg http://www.md-tim.com/mechmate/most/most2.jpg http://www.md-tim.com/mechmate/most/most3.jpg http://www.md-tim.com/mechmate/most/most4.jpg http://www.md-tim.com/mechmate/most/most8.jpg |
Impressive. Well done
|
Very cool. I like it. :)
|
my favourite.
http://www.md-tim.com/mechmate/most/most9.jpg |
Very Nice. :) Was this your design, or did you get cad files for this?
|
My design. I only got pictures of finished bridge, it had to be suprise so they did not ask for files from architects
|
Very well done.
|
That must have been a very loooong night!!!
Looks great! |
beautiful
very impressive work |
Brilliant!
|
How did you keep all those small pieces on the table while cutting ?
|
|
Danilo,
Very cool. Congratulations on an excellent job. Please share with us some of the details of how you did the job. Thanks |
way too cool
|
Its 3mm forex sheet I used double sided tape, but it was too thin and it required me to hold it down with my hand sometime (watch your fingers :) ) becouse no matter what it would pull it up its just to flexible. I tryed climbmill inside and conventional outside, becouse of material vibration (inside lines are 1-1.5mm and would brake on first test) so it doesnt tear thin lines. Edge was fine but required some work becouse forex has a thin layer on both sides (used for printing) and it swarfs (I think this is the right word)
Small pieces were made using 4 bridges 2mm wide and 1mm just enough to hold it down so it would not fly on to router bit after being cut out. Router bit used was 2mm endmill |
Very Nice!
You are taking away jobs from the laser guys!! Great! Had to google that republic name, I knew Bosnia Herzegovina, but Republika Srpska was new to me. Regarding the job, what I do sometimes with thin sheets is prepare an extra gcode program for drilling 1 mm holes in areas I will not cut and then hammer small nails all over the place, this adds some unevenness to the material (it compresses a little more around the nail) but I solve it by making the cuts a little deeper, the spoil board suffers but the job gets done! |
Very impressive! Good job pal!
|
Would it be too much to ask for dxfs and such? :)
This would make a nice gift for a nephew of mine :) |
Send me your email to PM. :) will be glad to share
|
All times are GMT -6. The time now is 05:25. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.