Mach3 X axis with 2 motors set as slave
 

Hello,

I need some help, i have 2 motors for x axis. In mach3, one motor is set to X axis and second in A axis.

In mach3 i set Config->Slave Axis on X Axis i set slaved axis to A axis.

Now then i press left button both motors axis rotating the same side, but if i press right button both motors axis rotating to different sides ? Can't find answer to this problem.

Thank you for help !

Are you sure that each motor will turn forwards and backwards? Maybe you are seeing the one motor only go in one direction? Maybe it does not change direction because there is a broken wire, or there is an incorrect setting?

it looks like you did not correctly wire the step and dir signals or set them properly in mach3 config pins, in those cases you can see that kind of behavior. disengage the motors and you should find one that is spinning in only one direction so check that motors setup.

You might also has a loose parallel port connection.

Thank you for help, i changed LPT cable to new one.

Also set in mach3 options showed in screenshot

Also in X Axis we can uncheck "Step Low Active" and the motors still rotating to the same side.

Depending on the Breakout board and the drives, all step signals should be checked or unchecked, so they all react in same fashion.

check step/dir wiring to the drives.
Also depending on the drives they might be configured for CW/ CCW input rather than Step/Dir this might be the most obvious reason as you are feeding the step signal into only one direction input. In leadshine drives there is a jumper inside or a dip switch setting to change this to the step/dir logic for the two inputs

Posted the screenshot but forgot to tell that now everything is working :) the problem was in LPT cable. Now my both motors work perfect and rotating to the same side. Thank you for quick answers.