MechMate CNC Router Forum - Gcode for surfacing table

MechMate CNC Router Forum (http://www.mechmate.com/forums/index.php)

- CNC motion control software (http://www.mechmate.com/forums/forumdisplay.php?f=21)

- - Gcode for surfacing table (http://www.mechmate.com/forums/showthread.php?t=993)

DMS	Fri 19 September 2008 12:48

Gcode for surfacing table

Gerald I do not know if this is right thread for this? As far as I remember JR also had similar question.

Is there any particular sequence in gcode while surfacing table or should I put simple gcode for doing so?

skypoke

Tue 07 October 2008 18:35

DMS,

If you're using Mach, there is a surfacing wizard. Find it on the top toolbar.

Chuck

DMS	Sun 12 October 2008 09:09

Thanks Chuck, I was not aware of that. I used JR's file for my setup.

All times are GMT -6. The time now is 13:23.